Here you can learn how to repair garage door cable. When considering replacing garage door cables. Make sure you are cautious and careful when replacing the cables. The garage door cables keep the whole door intact and functioning. So if needed, get someone else to help you with the door or contact a garage door service company that can help you if you’re not comfortable with replacing it yourself.
We have some easy instructions for you in this post that will help you learn how to replace garage door cable. So let’s get right into it….
First off, always make sure you know the exact problem that’s wrong with cables before messing with them. It might be an issue that can be fix instead of replacing them. If you find that the cables are simply disconnected then you can fix this by reattaching them. You should only replace the cables if they’re broken or totally worn out.
So if they need replacement, make sure you got all the necessary supplies to take care of the job. You’ll need some vice grips and a ladder to climb up to the cables. You’ll also need a pair of scissors, wrench, and Flathead screwdriver to get the job done. When you’re ready to remove the old cables. You can start by lifting the Garage door off the ground a couple feet high.
Then use the vice grips on each track to keep the door from coming down as you let it go. Now you can begin working on the door without it falling back down. Start using the screwdriver to remove all the wiring from brackets. Now take the wrench to loosen up the bolts just enough for you to remove the wire all the way.
Once that’s done you can start to install the new cables. Cut the wrapping on the cables off and unroll the wire. Put the new wire in the exact same place the old wire was in. Make sure it’s secure inside the bracket. Put it in the slot as you keep the wires along the garage door. Use your wrench to tighten the bolts so the wires stay in place.
After those steps remove the vice grips and check to see if everything on the garage door is working by opening it and closing it a few times. If done correctly, you should see the wires guide the door down and them remain on the tracks.